• meanmon13@lemmy.world
    link
    fedilink
    arrow-up
    4
    ·
    1 year ago

    Don’t forget trying to guess if the RX label is the line they transmit out of or you transmit to.

    • exu@feditown.com
      link
      fedilink
      arrow-up
      3
      ·
      1 year ago

      Isn’t it supposed to be from your device’s perspective?
      An RX on your side would be TX on the other.

      • meanmon13@lemmy.world
        link
        fedilink
        arrow-up
        3
        ·
        1 year ago

        Not always, it really depends on what the person who did the board layout or wrote the firmware thought. When I do a board/firmware I label it from the devices perspective, so the TX is where the bits I’m transmitting will be coming out of, RX is where I’m expecting your bits to be sent to. Others label it from the perspective of the device connecting to it. So TX is where you connect the line your sending bits from. To me that’s wierd because, to others it’s what they expect. There is no standard and the result is you end up hooking it to an oscilloscope and see which line bits are being sent from. Then you use the scope to figure out all the settings. If they don’t transmit in power up then… Frustration ensures

    • Doxin@yiffit.net
      link
      fedilink
      arrow-up
      1
      ·
      1 year ago

      Which is why for a lot of serial protocols nowadays they changed the labeling to MOSI/MISO instead of TX/RX