Replacing a broken set of blinds in my house and apparently no one sells the old standard kind where you pull the cord to raise them, I guess because kids and/or pets could tangle in the cord? Bit of an education in miniblinds today.
Replacing a broken set of blinds in my house and apparently no one sells the old standard kind where you pull the cord to raise them, I guess because kids and/or pets could tangle in the cord? Bit of an education in miniblinds today.
That is the only kind I know of. How does the other kind work?
Edit: should have been more specific; the string ones are the ones I know of.
We use honeycomb blinds here. You can get them in partially transparent or blackout. They are spring-loaded, and you really can’t use them wrong, pull them up or down as fast or as crooked as you want.
This is the only kind I know:
I think those are the ones being referred to. Nowadays they makes ones that look almost identical but don’t have the pullstrings. You can just raise and lower them from the bar on the bottom.
Which suck if you have windows higher than your head. Pullstring can be ten feet long and work just fine.
You lift them from the bottom and there is a system of gears and springs (citation needed) that assist with them being raised and hold them in place.
Pull them down from the bottom and they come down (with some resistance).
Huh. The string ones can be mounted inside the window. I guess these can’t then.
They can! They look identical to the old blinds, just without the string. I had to ask if the installers forgot the strings when we got new ones a few years ago!
Wait, I meant like in between the glass of the windows. If you have to pull and push the blinds themselves that would not work… right?
Are you saying that they’d be in between 2 stationary panes of glass? That sounds like a nightmare to deal with anyway.
Stationary for usual operations, at least. There is usually a mechanism to open it up so you can mend them if necessary.
I have some of those. There’s just a sliding mechanism built into the pane on the inside. No string. Much cleaner look and so much easier to use.
The ones I put up in my house have a high tension spring inside the top. When you want to raise the blinds you lift them up when you want to lower the blinds you pull them down. They’re not fantastic but they work well enough. You have to kind of coax them to go up lift them up a few times but then again mine were the cheapest Walmart had available
I’ve got the Ikea version of these and they work great, no coaxing at all. Way easier than that stupid pull cord, I would never go back. Put them up all over the house. One of them went slightly crooked and I never did figure out why or how to fix it though. I think I will eventually get some higher quality replacements anyway.
I love that thing when i saw it, unfortunately i can’t have it because i suspect my cat will destroy it in a week, so i got a cheapo one with beaded cord that loop. I guess i have to tie that up for safety.
I also use the cheapest Walmart ones and they’re fine - much better than the “try 15 angles till you find the right one” cords. The trick is to raise them slowly and gingerly so that you’re not just bunching up the blinds.
My favorite thing about them is the snap-on installation. No more sketchy slide-in plastic cubes with a plastic cover. Just drill the metal clamp on and snap them in. Surprisingly sturdy.
I actually didn’t know the old style was “illegal.” I just thought they were so unpopular that they replaced them, even at the most basic option.
By some mechanism I don’t quite understand, you just grab the lower bar and either lift up or pull down.
Mine have a hard “handle” with a string attached to it on a pulley. Twist the handle to adjust the angle, pull the string down on one side to open them, pull the string down on the other side to close.